We just need your E-Mail and shipping address.
Feel free to add more samples to your sample cart afterwards.
planeo is the brand for professional solutions with tested quality. In our extensive range, you will find first-class products for home and garden, from floors to wall coverings to decking: we offer you suitable items with a top price-performance ratio for almost every requirement and budget. We also have product lines such as carpets, wall paints, wallpapers and doors. The range of attractive offers for walls, floors and patios is rounded out by high-quality accessories and effective cleaning and maintenance products. Meanwhile, planeo's services go beyond the trade in floor coverings.
We put great emphasis on the idea of service in everything we do. We deal with the topics of material, handling and realisation in such detail that we can provide you with an adequate solution for many different situations on the building site. To make things more clear, you can find useful tips and instructions in our guides with articles and videos. Beautiful flooring and more? Realise easily with planeo.
|Length in mm||10050|
|Width in mm||530|
|Removal method||nass zu entfernen|
|Seal of approval||RAL-GZ 479|
|CE mark||DoP1, B-s1, d0|
|Piece per package||1|
|Package Content||5.33 m²|
Show all data ▼
We will help you with your questions!
A specialist adviser will be happy
to advise you personally.
☎ +49 5222 960 4810
Mon - Fri: 9am - 6pm
Sat: 9am - 2pm
Variant: DIY instructions
It is necessary to inspect the substrate before wallpapering. It should be clean, dry, and absorbent. Sand the walls and fill any cracks. The substrate is then primed after masking off all permanently installed items. This can be done with the basic paste, which should be diluted with 20 to 30 percent water. Apply the primer with a roller. The corners are painted with a brush.
Check the necessary number of strips. The role must be set up against the wall for this reason. With a pencil, make small markings at the intersections. To ensure that the wallpaper runs straight, the reference line from the first strip is drawn. Measure the wall and cut the first strip.
Tip: Increase the required measurement by 2 cm to ensure that the first strip will work even with uneven walls.
ATTENTION: There are symbols on the back of the wallpaper to assist in installation.
With a brush, apply the proper wallpaper adhesive to the edges, and then use a roller to coat the strip's surface. The wallpaper is then straightened along the drawn line and pressed on with a spatula. Remove any air pockets. The edges of the wallpaper can be cut off cleanly with a cutter knife. Cut the next strip according to the size of the first one. After applying the glue, utilise the edges of the already glued strip as a guide. Roll the wallpaper joints with a seam roller in the next step for a seamless transition.
Tipp: Residual paste should be wiped off immediately with a clean cloth.
To wallpaper the edges, measure the area and cut the needed strip to size. Then apply the paste and straighten the sheet on the first surface. The first side can now be squeezed and trimmed to size with the spatula. A sponge dipped in water can be ran over the edge to ensure a clean edge before folding it over. Apply pressure to both sides to do this. Finally, slide the spatula along the edge and pull taut away from it.
To make your own, you will need this
- Paste (ideally ready-made paste)
- Cutter knife
- Paint roller
- Paint brush
- Plastic spatula
- Seam roller
- Cleaning rags
- Corner rails
- Vacuum cleaner
Are you looking for a lower price? Just ask us for an individual offer!