The vinyl floors from the Loose Lay collection by Project Floors are hard-wearing and quick to install:
- renovation friendly & easy to install the special structure of the material allows for quick installation on the specified underlay
- hygienic & easy to clean the flooring is inexpensive to maintain and easy to clean
- special design the high-quality design in wood or stone look creates an authentic surface
- free of harmful substances
The name PROJECT FLOORS has been associated with high-quality LVT floor coverings since 1999. The abbreviation "LVT" stands for luxury vinyl tiles and indicates that these are PVC-based floorings. The PVC designs from PROJECT FLOORS are available in ceramic concrete, sand or plain colour finishes that replicate the look of natural materials. They combine the authentic look of the original materials with the robustness and ease of care of synthetic floor coverings.
|Length in mm||914|
|Width in mm||183|
|Thickness in mm||4.2|
|suitable for||Business, Industry, Bath, Kitchen, Bedroom & living room, Hallway & Corridor|
|installation pattern||Plank pattern (1-plank)|
|Underfloor heating||Warmwasser-FBH geeignet|
|Warranty||15 Jahre Privat, 5 Jahre Gewerbe|
|Piece per package||10|
|Wear layer||0,55 mm|
|Package Content||1.67 m²|
Show all data ▼
|Project Floors LooseLay - Datenblatt|
|Project Floors LooseLay - Verlegeanleitung|
|Project Floors LooseLay - Reinigung und Pflege|
|Indoor Air Comfort Gold - Zertifikat|
We will help you with your questions!
A specialist adviser will be happy
to advise you personally.
☎ +49 5222 960 4810
Mon - Fri: 9am - 9pm
Sat: 9am - 2pm
The substrate should be permanently dry, load-bearing, level and firmly bonded. Clean the surface to be installed with a hoover.
CAUTION: Never install vinyl over laminate or a soft subfloor e.g. carpet, cork or any type of foam underlay.
The vinyl planks should be stored horizontally in the room in which it is to be installed for 24-72 hours before the installation in the packages. This will allow the material to acclimatise to the room temperature and not "work" so hard after the installation.
Before laying, it is imperative that the official laying instructions, which are included in each package, are followed, otherwise any claim to warranty and guarantee will be invalidated!
The next step is to stick on the tape strips. Please always follow the installation instructions here as well, as this step can vary depending on the manufacturer. The edge areas are taped off to fix the vinyl planks. The strips can now be rolled on so that any air bubbles that have formed can be released and the planks get a firm hold.
Tip: To achieve as uniform a floor appearance as possible, it is advisable to install panels mixed from different packages.
Once the tapes are firmly stuck down, you can remove the foil from the tape strip for the first row. Now you can start laying in one corner (left) and starting from the wall. Hold the right side of the vinyl plank slightly higher than the left side and tape the plank to the tape, following the arrows. For the next planks, make sure that they are laid butt to butt with the planks already in place and that the ends are flush. To cut a plank, now take measurements and mark the plank. Then take an angle and tear the plank with a cutter knife. Before cutting, remove the protective film from the back of the plank.
Attention: A distance of approx. 1 cm must always be maintained between the flooring and the wall as well as to all fixed components.
- Loose-lay vinyl
- Professional cutter knife
- Folding rule
- Steel ruler
- for a room size of 15-20 m² approx. 2-3 hours
Level of difficulty:
Are you looking for a lower price? Just ask us for an individual offer!