Gerflor adhesive vinyl self-adhesive - Design Black Tile (32370221)

0.08 mm wear layer - 22 private (normal) - solid vinyl - without bevel - stone look - tile format - easy installation - suitable for damp rooms - non-slip - environmentally friendly

Item no.: 32370221

Quick and easy to install.
Antistatic and easy to clean thanks to PUR surface coating.
Modern and decorative.
Formaldehyde and solvent-free.
Without harmful plasticisers.
Suitable for damp rooms - waterproof and non-slip.
100% recyclable.

Offer request

Description

Technical data

Product description

Easy to clean and antistatic

Gerflor

Gerflor, a leading flooring manufacturer, has a 70-year history of producing resilient floor coverings for residential and commercial applications. The French company was founded in Lyon in 1937 and always focused on innovation, healthy materials and aesthetic floor design when developing new flooring solutions. Gerflor is right about its success - numerous awards attest to the first-class quality, the design, and the environmentally friendly aspect of Gerflor products. The Red Dot Award competition honors Gerflor's Creation 70 with the Red Dot Award for Product Design 2016.

item no.: 32370221

Easy installation & care
Without harmful plasticisers
Suitable for damp rooms
100% recyclable

Technical data

item no.	32370221
Manufacturer	Gerflor
Collection	Design
Length in mm	305
Width in mm	305
Thickness in mm	1.5
Wear layer	0,08 mm
Wear class	22 Residential (moderate)
suitable for	Private, Bath, Bedroom & living room
installation pattern	Tile format
Installation type	self-adhesive
Sorting (grain)	natural/classic
Look	Stone effect
Warranty	7 Jahre Privat
Special features	Suitable for humid rooms, Waterproof
EAN	3475710186837
Structure	Full vinyl
Joint	No bevel
Piece per package	11
Style	Modern
Slip resistance	R9
Shipping group	M
Weight	2,60 kg / Packing
Colour	black
Range of application	Residential
Underfloor heating	Hydronic UFH compatible
Package Content	5 m²

Print page

DIY step by step

button

1. substrate preparation

The substrate should be permanently dry, load-bearing and even. Any unevenness is sanded down and filled with a floor levelling compound. Depending on the substrate, the preparation procedure may vary. Please check the installation instructions to see which preparation is necessary for your subfloor. The surface to be laid can then be cleaned with a hoover.

button

2. acclimatisation

The vinyl planks should be stored horizontally in the room in which they are to be installed for at least 24 hours before the installation in the packages. This will allow the material to acclimatise to the room temperature and not "work" so hard after the installation.

Before laying, it is imperative that the official laying instructions, which are included in each package, are followed, otherwise any claim to warranty and guarantee will be invalidated!

button

3. before laying

Apply the bonding primer to the substrate in preparation for bonding to improve adhesion.

Tip: To achieve as uniform a floor appearance as possible, it is recommended to install panels mixed from different packages.

button

4. installation instructions

You can start with the installation on the left side of the room or in the middle of the room. First remove the protective foil and lay the first plank well aligned on the subfloor. Now press the plank firmly into place. The next planks are laid butt to butt with the planks already in place. Please note the laying direction on the back of the planks. To cut a plank, now take measurements and set the marks. Then take an angle and tear the plank with a cutter knife and break it off.

Attention: A distance of approx. 5 mm must always be maintained between the flooring and the wall as well as to all fixed components.